Recommended Substrates: 100% cotton, 100% Polyester, Poly/Cotton blends & untreated canvas.

Items needed: Computer, Graphics Software, Laser printer, Laser Tech Transfer Paper, Heat Press
Recommend Application
Application Instructions:

1) CREATE DESIGN - Using graphics software, create a design and output it to your laser printer. Remember to use the by-pass tray and select a thick paper setting. Don’t forget to mirror your design.

2) PRINT DESIGN - Feed the short side, stripped edge of paper into printer making sure the stripped edge is all on the same side . Do not stack more than 30 sheets at once. Fan sheets prior to loading to make sure they are loose.

3) PREHEAT GARMENT - It is extremely important to preheat the garment before application. Press garment for 4 seconds to remove moisture and chemical treatment from the transfer area.

4) POSITION DESIGN - Position the design with logo facing upwards on the garment. Place a protective cover
sheet over the design.

5) HEAT APPLY - Heat apply the design for 20 seconds at 400º F using MEDIUM (approximately 40 lbs.) of pressure.

6) PEEL and REVEAL - For best results, wait 3-5 seconds for a T-shirt and 5-10 seconds for a sweatshirt before peeling transfer sheet. PEEL HOT!


TIPS :
*Best performance is obtained on cotton, polyester, poly/cotton blends, and untreated canvas.

*Laser Tech functions in most color laser printers. To be sure, verify your make and model with the manufacturer or distributor prior to printing.

IMPORTANT: Please keep your Laser Tech transfer paper in the plastic bag until actual use. This will keep moisture out of the paper. Close the bag after each use.		  
CARE INSTRUCTIONS:
** Turn garment inside out & machine wash in warm or cold water using mild detergent.
** Do not bleach.
** Tumble dry at a low setting.
** Do NOT iron directly over design.
** Do NOT dry clean.

All technical information and recommendations are based on tests we believe to be reliable. However, we cannot guarantee performance under conditions not under manufacturer's control. Before using, please determine the suitability of product for it's intended use. The user assumes all risk and liability whatsoever in connection with the use of this product. Seller's and manufacturer's only obligation shall be to replace such quantity of the product proved to be defective by the manufacturer.