Recommend Application - Nylon, leather and other tough substrates.
*Reminder, SPECTRA™ CUT PLUS designs must be cut in REVERSE.

Application Instructions:

1) REMOVE - Remove the protective pink liner from the adhesive side of SPECTRA™ Cut Plus prior cutting.

2) PREHEAT - Preheat garment at a temperature of 320º F for 4 seconds to remove moisture and wrinkles.

3) APPLY - Apply SPECTRA™ Cut Plus designs to substrate for 2 - 4 seconds at a temperature of 320º F using LIGHT pressure.

4) PEEL - After garment has completely cooled, remove mylar backing from SPECTRA™ Cut Plus. PEEL COLD!

5) COVER - Cover the garment and SPECTRA™ Cut Plus with a Teflon sheet and heat press for an additional 10 seconds at temperature and pressure listed above. PEEL HOT!

Roll Size: Width 15" x 5 yd., 10 yd., 25 yd., & 50 yd. rolls		  
CARE INSTRUCTIONS:
** Machine wash using mild detergent at 176º F max.
** Dry at a normal dryer setting on household machines.
** Do not iron directly onto this material.
** Do not dry clean.

All technical information and recommendations are based on tests we believe to be reliable. However, we cannot guarantee performance under conditions not under manufacturer's control. Before using, please determine the suitability of product for it's intended use. The user assumes all risk and liability whatsoever in connection with the use of this product. Seller's and manufacturer's only obligation shall be to replace such quantity of the product proved to be defective by the manufacturer.